Knowledge Center

Causes of Damage to the Clutch Release Bearing2019/06/24 The clutch release bearing is subjected to axial load, impact load, and radial centrifugal force during high-speed rotation during use. In addition, since the fork thrust and the reaction force of the separating lever are not on the sa...
What is a clutch release bearing?2019/06/24 One specific thrust bearing in an automobile is the clutch "throw out" bearing, sometimes called the clutch release bearing.
Fault Resolution of Abnormal Noise of Clutch Release Bearing2019/06/24 Fault phenomenon: When the engine is running at an idle speed, the "click" sound can be clearly heard at the clutch release bearing. Failure analysis: During the engine idling, there is a noticeable "click" when the clutch ped...
How to Identify the Failure of the Wheel Hub Bearing2019/06/24 Wheel hub bearings are a simple but important automotive component that allows the wheels to rotate freely. Bad hub bearings should be replaced before it can be used to avoid damage to the car and damage to the person. 1. Sound: The...
Causes of Engine Crankshaft Fracture2019/06/24 First, the rounded corners of the crankshaft journal are too small. When grinding the crankshaft, the grinder fails to properly control the shaft fillet of the crankshaft. In addition to the rough machining of the arc surface, the rad...
The First Precautions in the Use and Installation of Bearings2019/06/24 1. In order to ensure maximum safety and reliability, it is recommended that you always check the wheel hub bearing regardless of the age of the car – pay attention to whether the bearing has early warning signs of wear, including any ...
The Knowledge of Clutch Release Bearing2019/06/24 The clutch release bearing is generally composed of an angular contact ball bearing, a bearing seat (or a sliding seat) and their couplings. If the clutch release lever, the lever damper, the duct, and the like are included, the clutch...
Causes of Damage to the Clutch Release Bearing2019/06/24 The separation bearing is subjected to axial load, impact load and radial centrifugal force during high-speed rotation during use, and since the fork thrust and the reaction force of the separation lever are not on the same line, a tor...
The Second Precautions in the Use and Installation of Bearings2019/06/24 1. For the wheel hub bearing unit, do not attempt to disassemble the wheel hub bearing or adjust the seal ring of the hub unit, otherwise the seal ring will be damaged and water or dust will enter. Even the raceways of the seal ring an...
Clutch Release Bearing Precautions are Open to the Public2019/06/24 The clutch release bearing is a relatively important part of the car. If the maintenance is not good, it will cause economic loss, and it takes a lot of labor to disassemble it once. Therefore, understand the cause of the failure of th...